· Emulator (the programmer) function elaborated
Emulator (the programmer) play an important role in the product development! GBPROG emulator is a product which can simulation debugging, programming. Its powerful:
1,Seamless connectivity with the integrated development environment IAR for MCS51 which simple to use, convenient, easy to learn, is indispensable development tool developers.
2,Connected to your computer via the USB interface, and then connect to the wireless microcontroller CC2540 (most of TI CC series products). Code for hig-speed download, download speeds of up to 150 kb / s;
3,USB-powered, plug-and-play, maximum current:500mA;
4,Line debugging, breakpoints, singlestep, variable observed, register observation function, (CC2540) series wireless microcontroller, most of TI CC series products (such as: realtime online simulation, debugging;Can burning program (hex the standard file program), which greatly improves the efficiency of the development.
5,With the TI CC Series chip protocol analysis.
6,GB-PROG Emulator (the programmer) support software
The IAR EW8051 7.51A versions and above
SmartRF Flash Programmer
SmartRF Studio
Packet Sniffer
· Emulator (the programmer) Description
GBPROG emulator (the programmer) is specific TI products in most of the CC series chip programming / simulation. The figure below shows the emulator (the programmer) with a USB cable and JTAG cable to connect the physical picture
The GBPROG emulator (the programmer) to meet the JATG programming standards. Emulator (programmer) connected through a ten core JTAG programming line with the target board, connected to the computer through a side port USB cable.
Use the following steps:
1, 10 core JTAG programming cable emulator (the programmer) and connected to the target board.
2, Square port USB cable (a rectangular mouth, a side port USB cable) emulator (the programmer) and PC connectivity.
3At this point, the computer will display the found new hardware installed driver (driver installation, please see Part 3 of this document). After installing the driver, emulator (the programmer) can be used normally
JTAG cable sequence instructions:
Note: The burning process, 1,2,3,4,7,9 feet; motherboard must power supply, or can only recognize the emulator itself, does not recognize the module. Under normal circumstances, the green light only recognizes the GB-PROG red light means to identify the TI CC Series MCU
More details please login download center~!
|